how to replace ignition coil 03
Altair Club Cars How to Replace Ignition Coil 03-07 GMC Savana 1500 Van

How to Replace Ignition Coil 03-07 GMC Savana 1500 Van

Buy Now!

Brought to you by 1a auto calm your source for quality replacement parts and the best service on the internet hi i’m mike from 1a auto i hope this how-to video helps you out and next time you need parts for your vehicle think of 1a auto calm in this video we’re gonna show you how to replace an ignition coil on this 2005 gmc savana 2500 with the 6 liter v8 engine

The tools that you will need is a 7 millimeter and the 10 millimeter socket and ratchet to start off go to the driver’s side of the vehicle and you’ll see there is a panel right here and you’re gonna want to remove these two ten millimeter bolts that secure that panel and also you’ll see that there’s a latch back here pull that fort like back towards you and it

Should unhook that clip there and then you just want to remove those bolts and we’ll just fast forward as he does this now with the bolts removed you can just pull on that panel screech underneath it and pull it out be careful not to pull out the panel’s above it now on the other side there’s again there’s two more ten millimeter bolts to carrying a panel you want

To just remove these two ten millimeter bolts and also like on the other side you want to pull back this pin this clip and unlatch that and we’ll fast forward as he removes these two ten millimeter bolts now you just want to pry this panel off pry off pretty easily now in the center of the center console underneath there’s two more of these latch clips and what you

Want to do is you want to just push up on the clips and free them and then once you have this unlatched just lift up and pull forward pull right out now to make more room for yourself the engine is behind this panel so what you can do is you can see it can’t come out of this vehicle the seats are in the way and the seats are only a few bolts if you want to remove

Them but if you just want a little bit more room to save time and what you can do is you can just remove you see there’s four ten millimeter bolts inside this this panel you just want to remove those okay with those bolts out you can now pull that panel up and off and remove that little top piece and now with the overall access panel being shorter you can push it

Under the dash and now you can access those spark plugs and ignition coils if you push it under the driver’s side you can see the other spark plugs in ignition coils we drew up this diagram to help you out if you have a code reader and you know what ignition coil is misfiring this will tell you which ignition coil that is on your engine so the driver’s side front

Of the engine spark plug would be one then it goes back three five and seven on the other side is the evens then it goes to four six and eight in this video we’re going to show you how to replace number eight but it’s the same process for all of them so here’s ignition coil number eight you just want to disconnect the harness and remove these two seven millimeter

Bolts there’s one on this side and then there’s another one just opposite of it on the other side and we’ll fast forward as he loosens and removes these with the bolts out the ignition coil comes right off and you just unplug your spark plug wires and then get your seven millimeter bolts and tighten them in by hand to secure the ignition coil in place and once you

Have that secure just use the socket and ratchet to tighten it the rest of the way we’ll fast forward as he does this now you just want to reconnect your ignition coil just plug in that harness up there and plug in your spark plug wires so to put the panel back together what you want to do is you put that top piece on line up the the access panel when you just want

To keep pushing it back into place and what you’ll see you’ll see those those clips have to line up there’s hooks on the band on the floor of the van that you need to line the latch hook up with once you have it lined up you just want to start connecting all those latches so just hook on to the hook pull the tab and lock it and you want to do that with all four of

Them now you can replace the cupholder panel just put it into place replace those four ten millimeter bolts helps if you do it by hand you can hold onto it line up all the bolts just start it out by hand and then we’ll fast forward as he uses the ratchet to tighten them the rest of the way you now you can put on that little panel right there just clips into place

I’m gonna replace the panel underneath the driver’s side just push all the clips in you should hear them snap and then you just want to replace those two 10 millimeter bolts and we’ll fast forward as he does this you now you just want to push that panel into place on the passenger side you just want to line up the clips push it in and then replace those two 10

Millimeter bolts and then you are all set you we hope this helps you out brought to you by ww1 ayato calm your source for quality replacement parts and the best service on the internet please feel free to call us toll free 888 eight four four three three nine three where the company that’s here for you on the internet and in person

Transcribed from video
How to Replace Ignition Coil 03-07 GMC Savana 1500 Van By 1A Auto Repair Tips \u0026 Secrets Only Mechanics Know

Related Post